Once CPU key is correct make sure glitch2 is selected and click Create Xebuild and it'll ask if you want to delete the SMC. It should say the CPU key is correct.ħth. Then get the CPU key and type it in on the CPU key box. Use file: Ace Time files>trinity>300MHZ>62.6>.07 and make sure XSFC is selected and click program, (Green light should Show up on the chip for a few seconds)Ħth, Unplug everything, then Turn it on and it should boot Xell. After both are done it should say "Nands Are the same" if it says "Oh no" nands are not the same and you need to do it again until you get 2 of the same Nand reads.Ĥth make sure glitch2 is selected at the top right, then Create Ecc & Write Ecc.ĥth, unplug nand x wires, then program the Ace v3 chip. connect nand x, and On jrunner Click Read Nand, get at least 2 Nand reads. Trinity and Corona Diagrams are below:Ģnd, install the Nand reading wires make sure nothing is bridgedģrd, plug the power into the console but don't turn it on. Nand X with Programming Cord and USB cord.Īnd all the other needed bullshit to solder.ġst.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |